The Kohler Puretide should be on your watchlist if you want to switch to a bidet but are on a tight budget. This manual bidet seat connects to the water supply line of the toilet and installs quickly without the use of batteries or electricity and it is easy to accomplish this. We have enlisted simple steps here for Kohler Puretide bidet installation.
Steps in Kohler Puretide bidet installation
Step 1 : Mounting Plate installation
Overlay the mounting plate over the bowl’s mounting holes. Place the washers in the mounting plate’s apertures after that. Each bolt should now be inserted into the mounting holes through the mounting plate.
Step 2 : Installation of Kohler Puretide bidet Seat
Position the seat first by sliding it onto the mounting plate until you hear it click into place. now Verify the seat’s placement. If necessary, change the position. Remove the seat by pushing in the release button and sliding it forward to change the position. If necessary, move the mounting plate. The mounting plate bolts and nuts should then be tightly tightened. When you feel it snap into place, slide the seat onto the mounting plate.
Step 3: Connect the Water Supply
First, attach the seat hose to the T-valve. Connect the supply hose to the supply stop if necessary. Supply pipe to T-valve connection Verify the filter is installed. Install as necessary. Then Connect the seat hose to the inlet with an orange color. Connect the T-valve to the toilet tank’s water inlet. Open the water faucet. Check for leaks at every connection and make any necessary modifications.
Step 4 : How to use
When nobody is seated on the seat, water may spray. Until you are seated, do not turn on the water. Turn the handle away from you to turn on the spray wand. Twist the handle either away from you to increase the flow or toward you to lessen the flow to adjust the water pressure. Push the handle down until you find the required position to move the spray wand. Switch the handle toward you until it stops to turn off the spray wand.
Step 5: How to remove the Seat
Turn off the water supply before removing the seat. To turn on the water, push the button next to the water inlet on the right side of the seat. The seat can be moved forward.
Nozzle Choices – Nozzle No. 1 is pre-installed. medium intensity Two-hole soft spray nozzle houses with high water pressure or users that prefer a soft spray. Spraying heavily from No. 3. best for low water pressure setups.
Replace the Nozzles
Pull the wand out by hand. Grip the wand firmly, then pull the nozzle to remove it.
Decide on the new nozzle. Holding the wand firmly, push the replacement nozzle into position with the outlet holes facing up.
Changing the Nozzles
Pull the wand out by hand. Grip the wand firmly, then pull the nozzle to remove it. Decide on the new nozzle. Holding the wand firmly, push the replacement nozzle into position with the outlet holes facing up.
Step 6: Maintenance and Cleaning
When caring for your KOHLER product, bear the following in mind for the best results:
- Before using it on the entire surface, try your cleaning solution on a discrete region. Use aerosol products sparingly.
- After using cleanser, quickly wipe off surfaces and thoroughly rinse with water. Any overspray that lands on neighboring surfaces should be rinsed and dried.
- Cleaners shouldn’t be allowed to soak into surfaces.
- Utilize a sponge or towel that has been soaked. Never clean surfaces using an abrasive tool, such as a brush or scouring pad.
- Avoid letting any chemicals or cosmetics, including aftershave and nail polish, touch the seat.
- Dish soap and water make the best cleaning solution. Use a gentle cloth to dry after rinsing.